This mother board has the jspi1 jumper that is a 2mm type and smaller than the blackcat connector. The jspi1 jumper should be able to program the bios chip. I just got my blackcat and was a little dissappointed to see that I was sent ver. 1.7. I am a total novice and from reading the other msi link on this forum, figure I need pin outs and confirmation of which pins to solder on the jspi1 and blackcat board. I noticed that the MSI thread never came to a conclusion. Can anyone give me a bit of a walk through?
Thanks in advance,
Hank
Thanks in advance,
Hank