Please, can any one please clarify this part
"
1. now apply the external 5v power source to the VCC wire
2. load sb5101U script
3. AND BACKUP UP EVERYTHING
4. start up the blackcat software
5. disconnect usb cable from BCusb, remove the 5v power source and disconnect ISP
6. now plug in power adapter to modem and
7. then flash haxorware in the 5101 tab
thats all your done....test!
"
Line no. 3 & 4: after i load the script, clicking on any read button says "Reading blah blah blah" on the status...
but then i go and backup in the spi tab, till now the software is on, so what dous the author mean by "start up the blackcat software "
now for no. 5 after i complete the step i put the Bcusb back on to usb the script tab is gone, so what do i do next?
for 6 & 7 , if the tab is gone and i cannot connect in EJTAG mode, how do i flash it with HAX??