Sorry... another 'Flash memory detected but not found in Flash library'

[Andy8]

Hey! Hoping somebody can help, trying to read ST nand256w3a2bn6 with FlashcatUSB X-PORT but am getting nowhere... Not sure if I'm missing a setting somewhere but I feel so close, yet so far... I change from 3V and 5V and it got me a Chip ID whereas before it was showing 0x8E8E8E8E8E

Hoping somebody could point me in the right direction, console log below Thank you in advanced!

Welcome to the FlashcatUSB interfacing software, build: 643 Copyright 2023 - Embedded Computers LLC Running on: Windows (64 bit) FlashcatUSB Script Engine build: 312 Serial NOR memory database loaded: 499 devices supported Serial NAND database loaded: 66 devices supported Parallel NOR memory database loaded: 405 devices supported Parallel NAND memory database loaded: 267 devices supported OTP/UV EPROM memory database loaded: 46 devices supported Connected to FlashcatUSB XPORT, firmware version: 5.29 Detecting connected Flash device... Initializing Parallel NAND device mode Parallel NOR mode successfully initialized Attempting to automatically detect Flash device Mode NAND X8 ASYNC returned ident code: 0xDB0FEAAE7B Connected to Flash (CHIP ID: 0xDB0FEAAE7B) NAND device failed to load ONFI table Flash memory detected but not found in Flash library

 

[Flop]

Hey! Hoping somebody can help, trying to read ST nand256w3a2bn6 with FlashcatUSB X-PORT but am getting nowhere... Not sure if I'm missing a setting somewhere but I feel so close, yet so far... I change from 3V and 5V and it got me a Chip ID whereas before it was showing 0x8E8E8E8E8E

Hoping somebody could point me in the right direction, console log below Thank you in advanced!

Welcome to the FlashcatUSB interfacing software, build: 643 Copyright 2023 - Embedded Computers LLC Running on: Windows (64 bit) FlashcatUSB Script Engine build: 312 Serial NOR memory database loaded: 499 devices supported Serial NAND database loaded: 66 devices supported Parallel NOR memory database loaded: 405 devices supported Parallel NAND memory database loaded: 267 devices supported OTP/UV EPROM memory database loaded: 46 devices supported Connected to FlashcatUSB XPORT, firmware version: 5.29 Detecting connected Flash device... Initializing Parallel NAND device mode Parallel NOR mode successfully initialized Attempting to automatically detect Flash device Mode NAND X8 ASYNC returned ident code: 0xDB0FEAAE7B Connected to Flash (CHIP ID: 0xDB0FEAAE7B) NAND device failed to load ONFI table Flash memory detected but not found in Flash library

Hi,
Which HW version you are using? Cause it might not work with this build. Try older versions.

 

[Andy8]

Thanks for your reply How do I downgrade?

 

[Flop]

Thanks for your reply How do I downgrade?

Hi,
On this form you can find several Build versions. Depending of your HW version some of them could work. Try Build 570 or similar. Check this link:https://www.blackcatusb.net/index.p...-pro-and-classic-latest-all-in-one.457/page-2. Every time you switch the Build version, you have to delete the FlashCat from regedit, then you can run the new Build.
Good luck.