• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

dpc 3828

gianni

Member
bcus cannot detect the flash Spansion_S25FL064A
i did all the conection like sb6120 and i put a clip to give power to the modem
what hes wrong then??

06072af7cccbfc256949ed4a880d3e4a.jpg
 
Re-check all your connections etc as this chip is supported.
 
Ok need some more info ,
What version of fcusb hardware are you using ?
What software version ?
picture of your connections
what is stated on the console window of the software when you attempt a connection.
 
i also try to conect a external power to pin 2 5volts + gnd to case and also i did try to the flash
and he did detect for just 1 10 second the flash,i did check the conection all was fine
im keep tryng but i have same resoult,i did also try the last software update 3.92,same result
 
If you had a detection for a short while then your connections are ok , on your FCUSB what fo you have your vcc set to 3.3v or 5v ?
 
Are you using just an external power supply to power pin 2 or does this device have an ISP point ?
 
im just using external power supply a ttl device to give 5 volt s,i do not no iff this device have isp point,no idea
 
i did find this,now ouw can i use this isp point? what i need to conect there? gnd and isp?

cg3100disp.jpg
 
i maded
a solution hes to put a clip betwen isp and gnd
turn on modem whit the power supply and detect flash
Flash this one
 

Attachments

  • flash.rar
    6.4 MB · Views: 34
Back
Top