• Seems like hotmail /outlook is blocking emails from here so please refrain from using one of these accounts as you may not receive your authorization email.. many thanks

Toshiba TC58NVG2S0HTA00

zeeshan

New Member
my nand is toshiba TC58NVG2S0HTA00 and this nand is not write correctly in FlashcatUSB xPort please any one help me any suggestion
 
Last edited:

adami

New Member
I also did the correction, but when I compare never matches... (55%, 60%, 76%) can anyone explain or help?
 

adami

New Member
yes you say right i have same problem never compare matches 67%,56%
During the reading, I make a comparison with the created file and it always shows 99%, never 100%, will be normal considering the type of memory?
 

zeeshan

New Member
first i copy master nand and compare with save file its 99% match and if write this file is bad flash and compare 66% :(:(:(
 

zeeshan

New Member
the same... 55/66% ... any idea what it might be?
no idea friend , any master here see our problem and help please and may be tsop-48 problem one they find wp pin vcc may be anoter pin has not connect with xport
 
Last edited:

u129718

New Member
Hi.
I have a new project, copy the information from a Toshiba flash tc58nvg0s3htai0 installed on a motherboard of an Arris modem, and copy it into a new one.

I have to buy the FlashcatUSB xPort, and I would like you to detail me all the adapters that I need, there are many different ones and I need help to select the right.

Thank you.
 

babyoche

New Member
hello everyone
is there a fix for the toshiba TC58NVG0S3HTA00 ?
I'm unable to detect any toshiba
if I desolder the nand it will read find with the match1 but I'm unable to read the toshiba with the export and the 360 clip, I can read any other ship but the toshiba
 

TONYDSS

New Member
hello everyone
is there a fix for the toshiba TC58NVG0S3HTA00 ?
I'm unable to detect any toshiba
if I desolder the nand it will read find with the match1 but I'm unable to read the toshiba with the export and the 360 clip, I can read any other ship but the toshiba
That has nothing to do with Mach1 or any other programmer, if you check your 360 clip is smallest than the TC58 chip if you reduce a little bit not to much the 360 clip to make the TC58 to inter freely and push a little be forward the 360 clips contacts with a needle then you are good.
 
Top