ricktendo
Active Member
The FCUSB detects my SB5101 just fine, but this is useless because the program fails to load the FCS script, here is my console log
Dev should manually load and fix compatibility with all the scripts, because I am sure its the same problem with most (if not all) the scripts.
Code:
FlashcatUSB Script Engine build: 300
Welcome to the FlashcatUSB interfacing software, build: 568
LibUsbDotNet version: 2.2.8.104
Running on: Microsoft Windows 10 Pro (64 bit)
Serial NOR memory database loaded: 343 devices supported
Serial NAND database loaded: 28 devices supported
Parallel NOR memory (x8/x16) database loaded: 275 devices supported
SLC NAND memory (x8) database loaded: 130 devices supported
Connected to FlashcatUSB Classic, firmware version: 7.13
Firmware features supported: JTAG
BSDL definition not found for JEDEC ID: 0x0334917F
JTAG chain detected: 1 devices
JTAG TDI size: 5 bits
JEDEC ID: 0x0334917F (Broadcom 0x3349)
Unable to select JTAG device: BSDL not loaded
JTAG engine setup successfully
Checking for a device specific script to automatically load
Loading device specific script: BCM3349_JTAG.fcs
Loading FlashcatUSB script: BCM3349_JTAG.fcs
Script successfully loaded
Configure JTAG engine for MIPS processor
Error in script: JTAG.config function exception (line 6)
Dev should manually load and fix compatibility with all the scripts, because I am sure its the same problem with most (if not all) the scripts.