• Visit https://www.embeddedcomputers.net/ for Hardware; Software and all other things related to FlashcatUSB

BCusb can read s25fl128p but cant write pls help

Ok so on build 282 with firmware 1.09 it reas and writes 100% = Correct
With build 282 with firmware 2.02 it does not detect the flash ? Not Tested
with build 321 with firmware 2.02 it does not detect the flash ? Correct


With build 321 with firmware 3.01 it detects the flash but does not write ?

read ok.

and

write only 00 (zeros)
 
Ok i will let the developer know and see if he can rectify it .

Did you try it with the 5v setting and dip switches to the ON position yet ?
 
The developer tested this chip using 5v , now there is a possability he had it as a stand alone chip , If you cannot remove the chip i would not recommend using the 5v then.

I will speak to the developer regarding this and post back once i have an answer.
 
I have removed the bga24 and bridge 34 awg wires to Black cat pins.

The motherboard of receiver is 3.3V.

The motherboard send 3.3V in Vcc ,W# and Hold pins

Thank you.
 
Any update from the developer D3mon? I have the same issue writing to S25fl128p.
Read OK..
Write OK, but after checking the code in hex. most of the addresses is all blank or FFFFFFF
 
Did you try with the FCUSB on the 5v setting and both dip switches to the Enable (ON) position ?
 
I've tried 5v setting jumper enabled and both DIP switches ON, but still No luck.

Try Built 304 w/ firmare 1.09 still no luck
 
Did you try with just Build304 or have you tried the latest build and firmware as well ?
 
you have to set up vcc to W pin (9) so you can enable write on chip , without it you would only be able to read from it .
 
you have to set up vcc to W pin (9) so you can enable write on chip , without it you would only be able to read from it .
I have done that and verified via a multi-meter but I still can't write. I get an error message about being unable to read from USB. I can read the entire BIOS chip, though, I just can't write.
 
Back
Top